How to Fix a Leaky Lens on Your Underwater Camera?

Do you need to fix a leaky lens on your underwater camera? There could be two main reasons behind camera housing leaks. However, It can be fixed by following a few simple steps. You are suggested to get through the following post to get further details. 

If you want a leak free underwater camera or housing, you are suggested to look into the following post to find a few important steps. If you find any issues when trying to follow these steps, it is recommended to get connected with our professionals at revlightsecurity.com.

Here are the steps to fix a leaky lens on an underwater camera!

Now, you should follow up on the information below respectively to make your underwater CCTV camera system free of leakage. 

A: The first step is to prepare your camera in a well-lit spot where you won't be bothered.

B: The next step is cleaning the o-ring. To do this, follow the given instructions

• The first step is to remove the o-ring from the outer body of the camera. Remember not to drag it with anything sharp; otherwise, it may be damaged. 

• Clean the o-ring soft to make the camera free of leakage. 

• You have to check the o-ring since not all o-rings have the same diameter. You can only use the one that came with your housing. 

• The next step is to apply an o-ring lube. For this, you need to use a blob and dot it around the ring. To make sure the o-ring is evenly covered, gently slide it between your forefinger and thumb. This should not cause the o-ring to stretch. 

• When the O-ring is cleaned properly, you have to put it into the groove. 

C: After that, you have to fit the o-ring again on the underwater digital camera. This can be done by following the instructions below. 

• Before putting on an o-ring, it is compulsory to check whether the o-ring is completely dust-free or not. 

• Remember not to stretch the o-ring while putting it into the groove.

• Once you have put the o-ring into the groove, don’t forget to check it again to see whether it is dust and leakage-free or not.

• After that, you may insert your Fix Lens Underwater Camera into the housing and make sure it is positioned correctly.

D: Finally, you have to make the required inspections that have been listed below.

• Check whether the outer body of the underwater camera is properly locked. 

• Ensure that the synch cords have been screwed properly.

• Make sure all the switches are aligned properly.

This way, you can easily make your underwater camera free of leakage. For any further information, it would be beneficial to get connected with someone at our official website anytime and from anywhere.

If you are seeking the Best CCTV Camera Provider, you should definitely visit revlightsecurity.com and contact one of our certified professionals to purchase one of your desired cameras anytime.